Hide hairline scratches in your piano black finished surface
Hide existing scratches and makes the panel look brand new again!
Self healing TPU Film
Available in both LHD and RHD models
For Transmission Panel available now for AT and MT Transmission
Other models are also available just search it in our website
Mazda 3 BP Model and Turbo
Updated now with Sport button slot
LHD - Steering wheel on the LEFT side like most of the countries
RHD- Steering wheel on the RIGHT side like Australia, Thailand, Japan etc
Before and After TPU Application
Note: After few days the film will be cured and all surface are completely clear.
LHD Transmission Panel AT
LHD Window Button Panel
RHD AT Transmission Panel
RHD Window Panel Button
LHD Window Panel Button
Available now for old Mazda 3 14-19 both for LHD and RHD models!
14-16 A/T LHD
14-16 M/T LHD
17-19 A/T LHD - Low Spec Trans Panel
17-19 A/T LHD - High Spec Trans Panel
1. Prepare the spray bottle put water inside with 1 drop of liquid soap. Shake it.
2. Spray the panel surface and clean with microfiber cloth. Make sure no more dirt or any particles left. Close the door and window.
3. Spray again the panel and back of the TPU clear film. Make sure its dripping wet so you can slide it easily.
4. Put the TPU on top of the panel and fit it accordingly.
5. Spray again the top of the film to lubricate the pick tool. Draw out the trapped water inside to the sides. Scrape the tool in sequential pattern and not in random area to avoid trapped air bubble.
When spraying make sure it is dripping wet. Do not just moist the surface. It's like installing a tint in a window.
For cluster TPU, put a paper tape on both sides and use it as a handle so you can adjust it easily before scraping. Start with the inner part, up and down going to the right, the go back to the center, up and down scrape going to the left.
After installation, it is normal see some white marks or tiny bubbles. They will be gone once the TPU has been cured for 3-5 days.
For trapped big bubble, try to pull up the TPU again gently. Spray the surface so it will lubricate.
Do not pull up the TPU very fast as the adhesive might get stick on the surface and detach from the TPU
Search some Youtube TPU guides if you are still confuse.